Chicopee Comprehensive High School
___________
People Showing Support after 9/11 From Around The World
Show Your Support
Display these ribbons on your Web page to show your support for all those
affected by the terrorist acts of September 11
|
| Circuit Applet Help | ||
| There are two modes in Circuit Applet: Design mode and Run mode. You can change mode by clicking at "Design" and "Run" buttons at the top of the Applet. | ||
| Design Mode | ||
| 1. You can add, move, and remove
components from circuit. 2. You can add components by clicking at desired components in the toolbar. 3. You can move components by drag and drop. 4. You can remove components by pressing "del" key. Pressing the "Clear" button will remove all components. |
||
| Run Mode | ||
| 1. You can view properties (voltage,
resistance, and current) of components by moving the
mouse cursor over them. 2. You can change properties (voltage, resistance, etc) of components by clicking at it, which pops up a separate dialog box for editing properties. |
||
| Caution | |||||
You can not connect two or more wires
"directly" to components.
You will then see an error message "[name] is not connected properly". |
|||||
Copyright (c) 1998 Integer